Asphalt Anchor BoltHold SP10-38 Dacromet coated 6-pack

SP10-38K-D is a set of 6 asphalt anchors rated at 1,500 lbs. pull. The 6" long anchor is designed to mount plates, fences, machinery directly to asphalt surfaces. This model is coated with Dacromet. Dacromet is an automotive coating that increases resistance to SALT corrosion 100 fold. However, it is not compatible with the EPX2 anchoring cement. Use EPX3 Epoxy instead.

A 1.4" welded washer at the top of the anchor prevents the anchor from dropping below the surface as well as preventing the anchor from being pulled up into the mounting plate when the bolt is tightened. The washer incorporates a 3/8"-16 UNC female thread. The anchors are mounted flush with the surface of the roadway, so that attached devices can be removed without leaving dangerous screws or protrusions on the walkway. The anchors are pre-installed with a bolt and a washer.

The anchor requires a 7/8" hole 6" deep and the use of our EPX3 epoxy grout. For technical information, datasheets and installation manuals, please visit our main website.