SP18 is a heavy duty asphalt anchor rated at 2,500 lbs. pull. The 12" long anchor is designed to mount plates, fences, machinery directly to asphalt surfaces. For technical information, datasheets and installation manuals, please visit our main web site.
SP18-716 incorporates a 7/16-14 UNC female thread. The thread of the bolt inside the anchor should not exceed 2.5". The anchor requires a 1" hole 12" deep and the use of aN epoxy grout. DO NOT USE WITH CEMENT grouts, such as our EPX2. A 1.4" welded washer at the top of the anchor prevents the anchor from dropping below the surface as well as preventing the anchor from being pulled up into the mounting plate when the bolt is tightened.
The SP18 anchors are mounted flush with the surface of the roadway, so that attached devices can be removed without leaving dangerous screws or protrusions on the walkway.
The SP18-716 is a set of 6 anchors, each pre-installed with a bolt and a washer.
