SPECIAL ORDER ONLY
SP18-M12 is a heavy duty asphalt anchor rated at 1,100 Kg pull. The 300mm long anchor is designed to mount speed bumps, plates, fences, machinery directly to asphalt surfaces. The anchor is made of zinc plated steel.
The SP18-M12 incorporates a M12x1.75mm female thread. The thread of the bolt inside the anchor should not exceed 150mm. The anchor requires a 25mm hole 300mm deep and the use of a grout such as our EPX2, EPX3 or AGe2. A 37mm welded washer at the top of the anchor prevents the anchor from dropping below the surface as well as preventing the anchor from being pulled up into the mounting plate when the bolt is tightened.
The SP18 anchors are mounted flush with the surface of the roadway, so that attached devices can be removed without leaving dangerous screws or protrusions on the walkway.
This part number is a set of 6 anchors, each pre-installed with a bolt and a washer.